Apple M8889LL/A User Guide - Page 34

Attach the Cable-Management Arm to the Rack 1 If the rear rails of your rack are flush with the server's back panel or within an inch of it, position the cable-management arm so that the short side is closer to the server's back panel and the holes on the long side align with the holes on the brace on the right side. Place the cable-management arm over the U-shaped brace, and secure both to the rack with two of the screws provided. 2 Thread the hook-and-loop straps through the holes in the cable-management arm. If the straps are already attached, skip this step. 3 Attach the long side of the folding arm to the rear rail, using two of the mounting screws provided with the server. The cable-management arm attaches on top of the right brace. The mounting screws hold both in place. See "Connect Cables to the Server" on page 40 for details on connecting cables and using the cable-management arm. Attach the Cable-Management Arm to the Support Brace If the rear rails of your rack are more than an inch away from the server's back panel, you need to attach the cable-management arm to the support brace at the side of the server (not to the rear rail). Otherwise the arm will not extend properly when you open the server in the rack. 1 Use a very small Phillips screwdriver to disconnect the small clamp that wraps around the long end of the cable-management arm (next to the two oval holes). You'll use this clamp and screw to attach the arm to the brace. 34 Chapter 3