Belkin F1UP0002uk User Manual - Page 106

Print-Server Installation in Windows 98SE/Me/NT 1 If the DHCP server is unavailable or not found, the user will be 2 prompted to configure the TCP/IP settings of the Print Server manually. The default TCP/IP-address information in the Manual-IP mode will be what is shown below. 3 IP Address: 192.168.2.253 4 Subnet Mask: 255.255.255.0 Default Gateway: 192.168.2.1 DNS: 0.0.0.0 5 6 Make sure that the TCP/IP information configured here is correct and matches your network settings. Click "Next" to continue on to next step in the installation process. The Print Server will check if 7 the manually configured IP address in "TCP/IP Configuration" is in the same subnet as the connected computer running the installation utility. If the TCP/IP-address settings configured manually are in a 8 different IP subnet than that of the connected computer, the user will be prompted by an alert message. Click "OK" to go back and 9 configure the correct IP-address settings for the Print Server. 10 Note: If you want to change the TCP/IP settings of the Print Server at some point after the installation, you can use the Server-Manager utility's TCP/IP- configuration option. 11 11. The default wireless setting is "Auto" mode. The Print Server 12 will detect a connection to a wired-LAN network through the attached Ethernet cable. If the Print Server is connected 13 to a wired network, it will work in that network. To enable wireless mode, the Ethernet cable must be disconnected after final configurations. However, the Ethernet cable needs 14 to stay plugged in for the required wireless configurations in this section. For more detailed information about wireless settings, refer to the "Wireless Configuration" section. 15 16 17 106 section