Belkin F1UP0002uk User Manual - Page 18
If you want to change the TCP/IP settings of the Print
View all Belkin F1UP0002uk manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Installation Procedure section 1 2 3 4 5 6 7 The Print Server will check if the manually configured IP 8 address in "TCP/IP Configuration" is in the same subnet as the connected computer running the installation utility. If the TCP/IP-address settings configured manually 9 are in a different IP subnet than that of the connected computer, the user will be prompted by the alert message shown below. Click "OK" to go back and configure the 10 correct IP-address settings for the Print Server. 11 12 13 Note: If you want to change the TCP/IP settings of the Print Server at some point after the installation, you can use the 14 Server-Manager utility's TCP/IP- configuration option. 15 16 17 18
18
12
13
14
15
16
17
The Print Server will check if the manually configured IP
address in “TCP/IP Configuration” is in the same subnet
as the connected computer running the installation utility.
If the TCP/IP-address settings configured manually
are in a different IP subnet than that of the connected
computer, the user will be prompted by the alert message
shown below. Click “OK” to go back and configure the
correct IP-address settings for the Print Server.
Note:
If you want to change the TCP/IP settings of the Print
Server at some point after the installation, you can use the
Server-Manager utility’s TCP/IP- configuration option.
Installation Procedure
1
2
3
4
5
6
7
8
9
10
11
section