Belkin F1UP0002uk User Manual - Page 53
Internal DHCP Server
View all Belkin F1UP0002uk manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Print Server Manager section 1 The Print Server will check if the manually configured IP address is in the same subnet as the network or connected computer. If the TCP/ IP-address settings configured manually are in a different IP subnet 2 than that of the connected networking devices, the user will be prompted by the alert message shown below. Click "OK" to go back 3 and configure the correct IP-address settings for the Print Server. 4 5 6 Internal DHCP Server 7 Click the "DHCP Server" button to enter into the internal DHCP server's setting page. You can enable/disable the DHCP server and assign a range of IP addresses here. By default, the DHCP server is 8 disabled (recommended). When it comes to assigning an IP address to the Print Server, the internal DHCP server takes lower precedence to either getting an IP address from an external DHCP server or using 9 the configured static IP address. Both options are described in the "IP Settings" section above. 10 11 12 13 14 15 16 53 17