Brother International BAS-300G Basic Instruction Manual - English - Page 39

5. USING THE OPERATION PANEL (BASIC OPERATIONS) 3 Press the key. The sewing machine will switch to intermittent presser foot height setting mode. • " 4" will appear in the PROGRAM No. display, and the work clamp will rise to the setting value that appears in the menu display. (Intermittent presser foot height setting: 0.0 − 10.0) Press the or key to set the intermittent presser foot height. • The intermittent presser foot will rise or drop to the height of the new value that has been set. NOTE: After making the setting, be sure to turn the pulley once by hand and check that the intermittent presser foot does not touch the needle bar. 5225Q Motor-driven work clamp specifications " 1" Threading mode ↑ ↓ " 2" Work clamp height setting mode ↑ ↓ " 3" Intermediate work clamp height setting mode 4" Intermittent presser foot height setting mode 4 Ending setting mode * When memory switch No. 003 is set to "2" Pneumatic work clamp specifications " 1" Threading mode ↑ ↓ " 4" Intermittent presser foot height setting mode 4448Q Press the THREAD/CLAMP key. • The setting values will be memorized. • The work clamp will return to where it was before setting mode was started. THREAD/CLAMP indicator switches off Intermittent presser foot operation During standby When lowered While sewing 1 Intermittent presser foot lift amount 2 Intermittent presser foot height The settings can be made by the above operations. However, set the intermittent presser foot height to a higher setting than the intermittent stroke. * If it is set smaller, the intermittent presser foot will come into contact with the needle plate. 3 Intermittent stroke When making the adjustment, refer to "10-14. Changing the intermittent stroke" in the instruction manual CD. 5033Q BAS-300G, BAS-311G, BAS-326G 31