Brother International BAS-612 Instruction Manual - English - Page 37
Resetting, after, emergency
View all Brother International BAS-612 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
< PROGRAMMING ERROR indicator illuminating> • BAS-611 machines: While programming, if the sewing data exceeds the 28 to 190 mm range while programming or if the flap correction data is 50 mm or more, re-input the correct value (the range is 36 to 190 mm for a gauge width of 16 to 20 mm). • BAS-612 machines: The indicator will illuminate if the following are programmed: Seam length of less than 36 mm • Seam length of more than 190 mm The indicator will illuminate if the following are programmed with the PSW-31 switch set to ON: • A slant sewing program • Seam length of less than 28 mm • Seam length of more than 190 mm • An indicator illuminating in the AUTOMATIC or MANUAL mode Trouble has occurred in the input data. Input the data in the PROGRAM mode. ON MODE EMERGENCY STOP TROUBLE sw31 32 33 34 35 36 37 38 1-1111711117DEE OFF AUTOMATIC • MANUAL a • PROGRAM • KNIFE CHANGE CYCLE PGM. 0 BOBBIN COUNTER SET O UPPER BREAKAGE O BOBBIN EMPTY rt % PROGRAMMING "L"....1.-/ ERROR 'SW 2 SW4 SW I SW3 < EMERGENCY STOP indicator illuminating> * Press EMERGENCY STOP switch 0 to stop the carriage feed movement. EMERGENCY STOP BOBBIN COUNTER SET Resetting after an emergency stop • Press the EMERGENCY STOP switch again to cut the needle thread and move the carriage feed to the thread trimming position. The carriage feed will rise then and, at this time, the needle thread and bobbin thread trimmer knives can be operated. Press the EMERGENCY STOP switch again and press the start switch to return the carriage feed to the home position and to start sewing. EMERGENCY STOP 4f BOBBIN COUNTER SET -33-