Brother International BAS-612 Instruction Manual - English - Page 56
Error, Codes
View all Brother International BAS-612 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
ERROR CODES • The machine will not operate when characters unrelated to the program are shown on the LED displays, either on turning on the power or during sewing. Please contact your Brother dealer if error display cannot be reset. Contents of the codes are as below: E-1-** Switch-related error EA-** Sensor-related error E-2-** Machine-related error E-6-** Error related to thread breakage E-3-** Error related to the carriage feed E-8-** Error related to the corner knife -'----.. . Contents of Error Codes E-0-00 EMERGENCY STOP pressed while carriage feed moving. E-1-00 Start switch pressed when power turned on. E-1-01 Treadle pressed for padding cloth presser foot operation when power turned on. E-1-02 Treadle pressed when power turned on. E-2-00 Machine motor not stopping at needle up position. E-2-01 Needle not at up position at sewing start. E-2-02 Needle not stopping at up position at sewing end. E-3-00 Feed home position overrun (home side). E-3-01 Feed overrun. E-3-02 Feed time-up. E-3-03 Waiting for a feed command. E-3-04 Feed error at error reset. E-3-05 Feed fault stop. E-3-06 Overrun to home side when power turned on. E-4-01 E-4-10 E-5-00 Right flap sensor fault. Left flap sensor fault. Cycle program interrupted. E-6-01 E-6-10 E-7-00 E-8-01 E-8-02 E-8-03 Right thread breakage. Left thread breakage. Memory read/write fault. Corner knife rises at sewing start. Corner knife locker rod contacting knife bracket when the rod is caught. Corner knife contacting knife bracket while knife operating. Reset procedure See the footnote. Release start switch. Release start switch. Release start switch. Turn pulley to raise needle. Turn power switch off. Turn power switch off. Turn power switch off. Turn power switch off. Turn power switch off. Turn power switch off. Turn power switch off. Turn power switch off. Move carriage feed away from operator by hand. Same as emergency stop. Same as emergency stop. Cycle program will be cleared and automatically reset. Same as emergency stop. Same as emergency stop. Replace circuit board. Turn power switch off. Turn power switch off. Turn power switch off. If the EMERGENCY STOP switch is pressed while the carriage feed is moving, the feed motor and main motor will stop immediately. The machine will now be in the same status as when the power is first turned on. The carriage feed will remain in the same position as when the EMERGENCY STOP switch was pressed (see page 33). -52-