Brother International BES-1240BC Instruction Manual - English - Page 252

Chapter 11 List of Error Codes Code E-33 E-34 E-36 E-38 E-39 E-3C E-40 E-A1 E-A2 E-A3 E-A4 E-A5 E-A6 E-A7 E-A8 E-B0 E-B1 E-B2 E-B3 E-B4 E-B5 E-B6 Error Needle overhang (+X, +Y) Needle overhang (-X) Measures Set the embroidering area again on the personal computer or move the hoop to a sewable position. Needle overhang (-X, +Y) Needle overhang (-Y) Needle overhang (+X, -Y) Needle overhang (-X, -Y) Remove the presser foot according to the warning instruction (to enter the every other head mode). The status of presser foot is issued as an Set the embroidering area again on the personal alarm when every second machine is used. computer or move the hoop to a sewable position. Spindle motor lock Press . If the same error occurs frequently, the STOP spindle mechanism is faulty. Main PC board temperature too high This is not usually displayed. Spindle motor voltage too low Spindle motor voltage too high Main shaft motor CPU communication error Main shaft motor CPU communication command error Main shaft motor CPU send/receive error Main shaft stop position signal error Press after setting the stop position above the STOP pulley needle (100 degrees). If the same error frequently occurs, the parts related to the main shaft stop position sensor are faulty. Lower shaft CPU error This is not usually displayed. Thread tangle in rotary hook Lower shaft motor zero point error Check to see that no lint is clogged in the clearance of the rotary hook and press . STOP Lower shaft standby position error The rotary hook may be rotated forcefully. Press STOP to reset the error. If the same error occurs again, the lower shaft adjustment is not proper. Lower shaft motor mode error This is not usually displayed. Lower shaft communication error Lower shaft parameter error 250 BES-940BC • BES-1240BC