Brother International BES-1240BC Instruction Manual - English - Page 36
and the F table support F, so that
View all Brother International BES-1240BC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Chapter 2 Preparation of Embroidery Machine i o Pin t (A) y (A) u q Lower by 1 mm e 4. Mount four drilling bolts i, four spring washers !0, and four flat washers !1 respectively at the rear of F tables R t, M y, and L u. 5. Mount five thumb bolts on the steel pipe below the front leg. 6. Insert the pins attached to the rear of the F table R t, M (2 pcs.) y, and L u into the cover o on the leg. Adjust the height of the F table guide U q and the F table support F e so that the table top surface will become 1 mm lower than the bed top surface. After adjustment is finished, tighten each bolt securely. 7. Mount a drilling bolt i, a spring washer !,0 and a flat washer !1 in section (A) of F tables R t and L u. 34 BES-940BC • BES-1240BC
Chapter 2
Preparation of Embroidery Machine
BES-940BC • BES-1240BC
34
q
e
Lower by 1 mm
Pin
i
o
u
y
t
4.
Mount four drilling bolts
i
, four spring washers
!0
, and four flat washers
!1
respectively at
the rear of F tables R
t
, M
y
, and L
u
.
5.
Mount five thumb bolts on the steel pipe below the front leg.
6.
Insert the pins attached to the rear of the F table R
t
, M (2 pcs.)
y
, and L
u
into the cover
o
on the leg.
Adjust the height of the F table guide U
q
and the F table support F
e
so that the
table top surface will become 1 mm lower than the bed top surface.
After adjustment is
finished, tighten each bolt securely.
7.
Mount a drilling bolt
i
, a spring washer
!
0
, and a flat washer
!
1
in section (A) of F tables R
t
and L
u
.
(A)
(A)