Brother International CS7130 Operation Manual - Page 35

UTILITY STITCHES 3 Use a chalk to mark on the fabric about 5 mm (3/16 inch) from the edge of the fabric, and then baste it. 3 5 6 1 Wrong side of fabric 2 Right side of fabric 3 Edge of fabric 4 Desired edge of 4 hem 1 2 5 5 mm (3/16 inch) 1 Arm 6 Basting 1 2 10 Position the fabric with the edge of the folded hem against the guide of the presser foot, and then lower the presser foot lever. 1 2 4 Fold back the fabric inside along the basting. R 3 3 5 4 12 1 1 1 Wrong side of fabric 2 Right side of fabric 6 3 Edge of fabric 4 Desired edge of hem 5 5 mm (3/16 inch) 6 Basting 7 Basting point 7 5 Unfold the edge of fabric, and position the fabric with the wrong side facing up. 4 1 6 1 1 1 Wrong side of fabric 3 2 Right side of fabric 3 Edge of fabric 1 4 Desired edge of hem 5 Basting point 1 6 Basting 5 2 1 Wrong side of fabric 2 Fold of hem 3 Guide 11 Adjust the stitch width until the needle slightly catches the fold of the hem. R 1 Needle drop point When you change the needle drop point, raise the needle, and then change the stitch width. Stitch width 6 Attach blind hem foot "R". 7 Select a stitch. 8 Remove the flat bed attachment and make free-arm sewing possible. • For details on free-arm sewing, refer to "Stitching cylindrical pieces" (page 30). 9 Slide the part that you wish to sew onto the arm, make sure that the fabric feeds correctly, and then start sewing. 1 Thick fabric 2 Normal fabric ■■If the needle catches too much of the hem fold If the needle catches too much of the hem fold, adjust the stitch width so that the needle slightly catches the fold by pressing the "+" side of the stitch width adjustment key. 33