Brother International CS7130 Operation Manual - Page 66
right side of the needle plate. Then, use
View all Brother International CS7130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
APPENDIX 8 Remove the bobbin case. If threads remain in the bobbin case, remove them. 1 Bobbin case 9 Use the cleaning brush or a vacuum cleaner to remove any dust from the race and its surrounding area. If the fabric cannot be removed, even after completing these steps, contact your nearest authorized service center. 12 Remove any threads in the race and around the feed dogs. 13 Turn the handwheel to raise the feed dogs. 14 Align the two screw holes in the needle plate with the two holes at the needle plate mounting base, and then fit the needle plate onto the machine. 15 Lightly finger-tighten the screw on the right side of the needle plate. Then, use the discshaped screwdriver to firmly tighten the screw on the left side. Finally, firmly tighten the screw on the right side. 1 Cleaning brush 2 Race • If the fabric could be removed Continue to step 16. • If the fabric could not be removed Continue to step 10. 10 Use the included disc-shaped screwdriver to loosen the two screws on the needle plate. Turn the handwheel to check that the feed dogs move smoothly and do not contact the edges of the slots in the needle plate. Note • Be careful not to drop the removed screws in the machine. 11 Slightly lift up the needle plate, cut any tangled threads, and then remove the needle plate. Remove the fabric and threads from the needle plate. 1 Correct position of feed dogs 2 Incorrect position of feed dogs Note • Be careful not to drop the removed screws in the machine. 16 Insert the bobbin case by following step 7 in "Cleaning the race" (page 61). 17 Attach the needle plate cover by following steps 8 and 9 in "Cleaning the race" (page 61). 18 Check the condition of the needle, and then install it. • Refer to "Checking the needle" and "Replacing the needle" (page 21). 64