Brother International Innov-is XJ2 My Design Snap Application Instructions - Page 10

POSITIONING AN EMBROIDERY DESIGN (ADVANCED MODE) Positioning a Design Using the Advanced Mode To use the My Design Snap app to position a design, you will first need to hoop the fabric (with stabilizer) in one of the codified hoops and set an embroidery design. The example shown in this section uses the Advanced mode in the app and design 007 from embroidery category 1/subcategory 15. Subcategory Design After the selected pattern appears on the machine's screen, press Set key in the lower-right corner of the screen. On your smartphone, open the app and select the first icon . After the application pairs with your machine, change the mode to Advanced. 1. When you select the advanced mode, you will be prompted to attach an embroidery positioning sticker where you want the design to stitch. 2. Attach the sticker so that the center dot in the lower circle aligns with one of nine reference points for placement: center, upper left, upper center, upper right, left center, right center, lower left, lower center, and lower right. 3. When the embroidery frame capture screen appears, align the frame on the screen with the actual embroidery frame. The black marks at the top and bottom of the frame must align with the black circles in the app. 4. Position the smartphone so that the blue circles in the bars on the right and bottom of the screen are within the adjustment areas. When the countdown begins, the photo has been successfully taken. 5. Your smartphone will prompt you to send the image to your machine. You will receive confirmation when the design has been sent. 8