Canon PIXMA iP4000 iP4000 Quick Start Guide - Page 84
Cannot Print Properly from the Digital Camera - error power supply
View all Canon PIXMA iP4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Troubleshooting Cannot Print Properly from the Digital Camera The following are the possible errors that may occur when printing directly from a digital still camera or digital video camcorder*, and the countermeasures to eliminate them. *Hereafter, the digital still camera and digital video camcorder are collectively called a digital camera or camera. Camera Error Message Possible Cause Try This Printer in use Images are being printed from Wait until printing ends. The printer automatically starts the computer printing the images from the camera after completing the current printing. Printer warming up The printer is warming up Wait until warm-up ends. When it is ready, the printer starts printing automatically. No paper No paper is loaded Load paper in either the Sheet Feeder or Cassette which you have selected with the Paper Feed Switch on the printer, and select Continue*1 in the display on your camera. Paper error The Paper Output Tray is closed Open it to resume printing. If the Inner Cover is open, close it. Paper jam A paper is jammed in the printer Select Stop in the display on your camera to stop printing. Remove the jammed paper, load new paper, and press the RESUME/CANCEL button on the printer and retry printing. Printer cover open The Top Cover is open Close the Top Cover on the printer. No print head The Print Head is defective or not installed (The POWER lamp on the printer flashes five times.) Install a Print Head according to the Easy Setup Instructions. If the Print Head has already been installed, remove it to check for any dirt or debris at its contacts. After cleaning, reinstall the Print Head. If the error still remains, the Print Head may be defective. Contact the Customer Care Center. Waste tank (ink absorber) The waste ink absorber is full nearly full The printer has a built-in waste ink absorber to hold the ink used during print head cleaning. This error message indicates that the waste ink absorber is nearly full. You can continue printing for a while by selecting Continue*1 in the display on your camera. However, because printing is disabled once the waste ink absorber becomes completely full, you are recommended to contact the Customer Care Center as early as possible. Ink is low It is about time to replace the Select Continue*1 in the display on your camera to resume ink tank with a new one printing. Ink tank is empty Replace the ink tank with a new one Printing resumes once the Top Cover is closed after ink tank replacement. You can continue printing by selecting Continue*1 in the display on your camera with the ink tank empty. But, it is recommended you replace it with a new one immediately after printing. It may damage the printer if you continue printing with empty ink tanks. Printer error An error requiring servicing might have occurred (the POWER lamp on the printer flashes alternately orange and green). Select Stop in the display on your camera to stop printing. Disconnect the cable between the printer and the camera, turn off the printer, and unplug the power cord of the printer from the power supply. After a while, plug the power cord of the printer back in, turn on the printer, and then reconnect the camera to the printer. If the same error occurs, contact the Customer Care Center. *1 To resume printing, you can press the RESUME/CANCEL button on the printer instead of selecting Continue. 80