Cisco 10000-2P2-2DC Software Guide - Page 204

L2TP Network Server Chapter 5 Configuring the Layer 2 Tunnel Protocol Access Concentrator and Network Server Step 8 Step 9 Command Router(config-sg-radius)# exit Router(config)# radius-server attribute list listname Step 10 Router(config-sg-radius)# attribute value1 [value2 [value3...]] Purpose Exits server-group configuration mode. Defines the list name given to the set of attributes defined using the attribute command. Define the listname argument to be the same as you defined it in step 5. Adds attributes to the configured accept or reject list. You can use this command multiple times to add attributes to an accept or reject list. Verifying RADIUS Attribute Accept or Reject Lists To verify an accept or reject list, enter any of the following commands in privileged EXEC mode: Command Router# debug aaa accounting Router# debug aaa authentication Router# show radius statistics Purpose Displays information on accountable events as they occur. Displays information on AAA authentication. Displays the RADIUS statistics for accounting and authentication packets. Caution Because debugging output is assigned high priority in the CPU process, it can render the system unusable. For this reason, use debug commands only to troubleshoot specific problems or during troubleshooting sessions with Cisco Systems technical support personnel. Moreover, it is best to use debug commands during periods of lower network traffic and fewer users. Debugging during these periods decreases the likelihood that increased debug command processing overhead will affect system use. 5-38 Cisco 10000 Series Router Software Configuration Guide OL-2226-23