Cisco 10000-2P2-2DC Software Guide - Page 507

Chapter 22 Configuring Multilink Point-to-Point Protocol Connections Configuring MLP Bundles and Member Links Step 1 Step 2 Step 3 Step 4 Step 5 Step 6 Command Purpose Router(config)# interface multilink multilink-bundle-number Creates a multilink bundle. Enters interface configuration mode to configure the bundle. multilink-bundle-number is a nonzero number that identifies the multilink bundle. For Cisco IOS Release 12.2(28)SB and later releases, valid values are: • MLP over Serial-1 to 9999 (Release 12.2(28)SB and later) or from 1 to 9999 and 65,536 to 2,147,483,647 (Release 12.2(31)SB2 and later). • Single-VC MLP over ATM-10,000 and higher. • Multi-VC MLP over ATM-1 to 9999 (Release 12.2(28)SB and later) or from 1 to 9999 and 65,536 to 2,147,483,647 (Release 12.2(31)SB2 and later). Note For releases earlier than Cisco IOS Release 12.2(28)SB, valid values are from 1 to 2,147,483,647. Router(config-if)# ip address address mask Specifies the IP address and subnet mask assigned to the interface. address is the IP address. mask is the subnet mask for the associated IP address. Router(config-if)# ppp chap hostname hostname (Optional) Identifies the hostname sent in the Challenge Handshake Authentication Protocol (CHAP) challenge. hostname is the name of the bundle group. This name uniquely identifies the bundle. Note If you configure this command on the bundle and its member links, specify the same identifier for both the bundle and the member links. Router(config-if)# ppp multilink fragment-delay delay-max (Optional) Configures the maximum delay allowed for the transmission of a packet fragment on an MLP bundle. delay-max specifies the maximum amount of time, in milliseconds, that is required to transmit a fragment. Valid values are from 1 to 1000 milliseconds. Router(config-if)# ppp multilink interleave (Optional) Enables interleaving of real-time packets among the fragments of larger nonreal-time packets on an MLP bundle. Router(config-if)# ppp multilink fragment disable (Optional) Disables packet fragmentation. Note The router automatically adds the ppp multilink and ppp multilink group commands to the MLP bundle configuration. Configuration Example for Creating an MLP Bundle Interface Example 22-1 shows a sample configuration for creating an MLP bundle interface. OL-2226-23 Cisco 10000 Series Router Software Configuration Guide 22-29