Cisco 10000-2P2-2DC Software Guide - Page 369

Chapter 17 Cisco 10000 Series Router PXF Stall Monitor Configuration Example of Cisco 10000 Series Router PXF Stall Monitor Command or Action Step 5 exit Purpose Exits the global configuration mode. Step 6 Example: Router(config)# exit show pxf stall-monitoring [counters | reset {active-status | cob-fib | cob-tib | pxf-drop} subslot ] Example: Router# show pxf stall-monitoring Displays the current configuration and the operating status of the PSM. The command also display the number of stalls on the PSM after it was last enabled. You can use the following parameters: • counters-Displays statistical information for all the counters. • reset-Displays the following counters: - active-status-Displays the active status on the specified subslot. - cob-fib-Displays the Cobalt FIB counter on the specified subslot. - cob-tib-Displays the Cobalt TIB counter on the specified subslot. - pxf-drop-Displays the PXF per RSRC drop counter on the specified subslot. - subslot sub slot-Displays information about the specified subslot. Configuration Example of Cisco 10000 Series Router PXF Stall Monitor The following example shows how to configure and verify the PSM: Router# show pxf stall-monitoring pxf stall-monitoring : Disabled Router# configure terminal Enter configuration commands, one per line. End with CNTL/Z. Router(config)# hw-module pxf stall-monitoring Router(config)# exit Router# show pxf stall-monitoring pxf stall-monitoring : Enabled Stall History Stall Threshold Configuration Primary Action = LC-reset Threshold = 3 (default) Primary Action = HT-reset Threshold = 3 (default) Secondary action = SSO SwitchOver Router# configure terminal Enter configuration commands, one per line. End with CNTL/Z. Router(config)# hw-module pxf stall-monitoring HT-Reset 5 Router(config)# hw-module pxf stall-monitoring LC-Reset 4 Router(config)# exit OL-2226-23 Cisco 10000 Series Router Software Configuration Guide 17-65