Cisco 10000-2P2-2DC Software Guide - Page 488

Configuration Commands for MLP Chapter 22 Configuring Multilink Point-to-Point Protocol Connections Usage Guidelines For Cisco IOS Release 12.2(28)SB and later releases, the range of valid values for multilink interfaces are the following: • MLP over Serial-1 to 9999 (Release 12.2(28)SB and later), and 1 to 9999 and 65,536 to 2,147,483,647 (Release 12.2(31)SB2 and later) • Single-VC MLP over ATM-10,000 and higher • Multi-VC MLP over ATM-1 to 9999 (Release 12.2(28)SB and later), and 1 to 9999 and 65,536 to 2,147,483,647 (Release 12.2(31)SB2 and later) For releases earlier than Cisco IOS Release 12.2(28)SB, the valid multilink interface range is 1 to 2,147,483,647. ppp multilink Command To enable MLP on an interface, use the ppp multilink command in interface configuration mode. To disable MLP, use the no form of the command. ppp multilink no ppp multilink Command History Cisco IOS Release 12.0(23)SX 12.2(16)BX 12.2(28)SB Description The ppp multilink command was introduced on the Cisco 10000 series router. This command was introduced on the PRE2. This command was integrated into Cisco IOS Release 12.2(28)SB. Defaults The command is disabled. Usage Guidelines The ppp multilink command applies only to interfaces that use Point-to-Point Protocol (PPP) encapsulation. When you use the ppp multilink command, the first channel negotiates the appropriate Network Control Protocol (NCP) layers (such as the IP Control Protocol and IPX Control Protocol), but subsequent links negotiate only the Link Control Protocol (LCP) and MLP. ppp multilink fragment-delay Command To specify a maximum size in units of time for packet fragments on a MLP bundle, use the ppp multilink fragment-delay command in interface configuration mode. To reset the maximum delay to the default value, use the no form of the command. ppp multilink fragment-delay delay-max no ppp multilink fragment-delay delay-max Syntax Description delay-max Specifies the maximum amount of time, in milliseconds, that is required to transmit a fragment. Valid values are from 1 to 1000 milliseconds. 22-10 Cisco 10000 Series Router Software Configuration Guide OL-2226-23