Cisco 10000-2P2-2DC Software Guide - Page 523

Chapter 22 Configuring Multilink Point-to-Point Protocol Connections Verifying and Monitoring MLP Connections Keepalive not set DTR is pulsed for 2 seconds on reset LCP Open, multilink Open Open:IPCP Last input 15:24:43, output never, output hang never Last clearing of "show interface" counters 15:27:59 Queueing strategy:fifo Output queue 0/40, 0 drops; input queue 0/75, 0 drops 5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec 36 packets input, 665 bytes, 0 no buffer Received 0 broadcasts, 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 31 packets output, 774 bytes, 0 underruns 0 output errors, 0 collisions, 0 interface resets 0 output buffer failures, 0 output buffers swapped out 0 carrier transitions Verification Example for the show ppp multilink Command Example 22-13 shows sample output from the show ppp multilink command. In the example, information about the MLP over ATM bundle (Multilink3) displays first. Information about the member links then displays, including the number of active and inactive member links. Class fields are omitted from the output; everything is implicitly in receive class 0 and transmit class 0. Example 22-13 Sample Output for the show ppp multilink Command Router# show ppp multilink Multilink3, bundle name is multilink_name-3 Endpoint discriminator is multilink_name-3 Bundle up for 3d21h, total bandwidth 128, load 1/255 Receive buffer limit 24384 bytes, frag timeout 1000 ms Bundle is Distributed 0/0 fragments/bytes in reassembly list 1 lost fragments, 1 reordered 0/0 discarded fragments/bytes, 0 lost received 0x831D received sequence, 0x0 sent sequence C10K Multilink PPP info Bundle transmit info send_seq_num 0x0 Bundle reassembly info expected_seq_num: 0x00831E Member links: 2 active, 0 inactive (max 10, min not set) Vi5, since 3d21h, 16 weight, 82 frag size Vi4, since 3d19h, 16 weight, 82 frag size No inactive multilink interfaces The following list describes the bundle-level fields and lines in the show ppp multilink command output: • Bundle name is name-The bundle identifier for the bundle. • Bundle up for time-The elapsed time since the bundle first came up. • load n/255-The traffic load on the bundle as multilink computes loads for bandwidth-on-demand purposes. This load might count all traffic, or just inbound or outbound traffic, depending on the configuration. • Receive buffer limit n bytes-The maximum amount of fragment data that multilink can buffer in its fragment reassembly engine for each receive class. This amount is derived from the configured slippage constraints. OL-2226-23 Cisco 10000 Series Router Software Configuration Guide 22-45