Cisco SPA962-EU Administration Guide - Page 106
VLAN Settings, Enables or disables Cisco Discovery Protocol CDP.
UPC - 745883578504
View all Cisco SPA962-EU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
System Tab Field DNS Query Mode Syslog Server Debug Server Debug Level Primary NTP Server Secondary NTP Server VLAN Settings Field Enable VLAN VLAN ID Enable CDP Chapter 5 SPA900 Series Phone Field Reference Description Perform parallel or sequential DNS Query. With parallel DNS query mode, the 900 Series phone sends the same request to all the DNS servers at the same time when doing a DNS lookup, the first incoming reply is accepted by the 900 Series phone. The default is parallel. Specify the syslog server name and port. This feature specifies the server for logging 900 Series phone system information and critical events. If both Debug Server and Syslog Server are specified, Syslog messages are also logged to the Debug Server. The debug server name and port. This feature specifies the server for logging 900 Series phone debug information. The level of detailed output depends on the debug level parameter setting. The higher the debug level, the more debug information is generated. Zero (0) means no debug information is generated. To log SIP messages, Debug Level must be set to at least 2. The default is 0. IP address or name of primary NTP server. IP address or name of secondary NTP server. Description Enable this parameter if the switch to which the 900 Series IP phone is connected uses VLAN tagging. Enter the VLAN tag for the VLAN to which the 900 Series IP phone is assigned. This should be the same VLAN to which the SPA9000 is assigned. Enables or disables Cisco Discovery Protocol (CDP. The default is Yes. Linksys 900 Series IP Phone Administrator Guide 5-8 Document Version 3.0