Cisco SR224 User Guide - Page 21

IP Configuration, Firmware Update, MAC Address. The MAC Address of the Switch is displayed.

Get Cisco SR224 - Small Business Unmanaged Switch PDF manuals and user guides
UPC - 745883556526
View all Cisco SR224 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

24-port 10/100 + 2-Port Gigabit Switch with WebView IP Configuration IP information is displayed here. • MAC Address. The MAC Address of the Switch is displayed. • IP Address. This IP Address of the network is displayed. (The default IP address is 192.168.1.254.) Verify that the address you enter is correct and does not conflict with another device on the network. • Subnet Mask. The subnet mask of the network is displayed. • Default Gateway. The default gateway of the network is displayed. If you would like to change the IP address settings of the Switch, select Edit at he bottom of the screen. Firmware Update When new firmware becomes available, you can update the Switch. To update the firmware, select Firmware Update. When the message asks if you want to continue the update, select Y to continue or N if you want to cancel. IMPORTANT: Do not disconnect the power during a firmware upgrade. Damage to Switch could occur. After you select yes, the Switch will be set to receive the file. At the top of your screen, select Transfer from the Main Menu, then select Send File. Figure 4-11: IP Configuration Figure 4-12: Firmware Update Chapter 4: Configuration using the Console Interface Configuring the Switch through the Console Interface Figure 4-13: Main Menu 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
15
Chapter 4: Configuration using the Console Interface
Configuring the Switch through the Console Interface
24-port 10/100 + 2-Port Gigabit Switch with WebView
IP Configuration
IP information is displayed here.
•
MAC Address. The MAC Address of the Switch is displayed.
•
IP Address. This IP Address of the network is displayed. (The default IP address is 192.168.1.254.) Verify that
the address you enter is correct and does not conflict with another device on the network.
•
Subnet Mask. The subnet mask of the network is displayed.
•
Default Gateway. The default gateway of the network is displayed.
If you would like to change the IP address settings of the Switch, select
Edit
at he bottom of the screen.
Firmware Update
When new firmware becomes available, you can update the Switch. To update the firmware, select
Firmware
Update
. When the message asks if you want to continue the update, select
Y
to continue or
N
if you want to
cancel.
After you select yes, the Switch will be set to receive the file. At the top of your screen, select
Transfer
from the
Main Menu, then select
Send File
.
Figure 4-11: IP Configuration
Figure 4-12: Firmware Update
Figure 4-13: Main Menu
IMPORTANT:
Do not disconnect the power during
a firmware upgrade. Damage to Switch could
occur.