Cisco SR224 User Guide - Page 27

24-port 10/100 + 2-Port Gigabit Switch with WebView Collision Retry Forever. In a collision, a packet will be re-sent until it reaches its destination. To enable this feature, select Enable from the drop-down menu. To disable this feature, select Disable. MAC Table Auto-Aging. If there is no response froma network device when searching for a MAC address within the chosen time, the switch will remove the MAC address from the MAC address table. Select 150 sec, 300 sec, or 600 sec from the drop-down menu. To disable this feature, select Disable. MAC Table Hashing. Select from a choice of two algorithm type used to check the MAC address table to determine which MAC address is associated with what port or destination on the network. Select Direct Map or CRC (Cyclical Redundancy Checking) Hash from the drop-down menu. Console Auto Logout Time. The console will log out after the chosen time. Select 5 min, 10 min, or 20 min from the drop-down menu. Select Never to disable the feature. Web Auto Logout Time. The Web interface will log out after the chosen time. Select 5 min, 10 min, or 20 min from the drop-down menu. Password Setting This screen allows you to set a password for your Switch. Password Protection. To set a password for your network, select Enable from the drop-down menu. Enter your user name in the field, then the password. Enter the password again to confirm that it is correct. If you don't want to have a password to configure the Switch, select Disable. Figure 5-6: System Tab-Username/Password Setting Chapter 5: Configuring the Switch through the Web Utility 21 System Tab