Compaq nc6000 HP Compaq nc6000 Notebook PC - Maintenance and Service Guide - Page 136
LED board cable is attached and disconnect the cable, Remove the LED board actuator
View all Compaq nc6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 136 highlights
Removal and Replacement Procedures 3. Release the ZIF connector 1 on the system board to which the LED board cable is attached, and then disconnect the cable 2. 4. Lift the board straight up to remove it 3. 5. Release the ZIF connector 4 on the LED board to which the LED board cable is attached and disconnect the cable 5. 6. Remove the LED board actuator 6 from the notebook. Removing the LED Board Reverse the above procedure to install the LED board. 5-50 Maintenance and Service Guide
5–50
Maintenance and Service Guide
Removal and Replacement Procedures
3. Release the ZIF connector
1
on the system board to which
the LED board cable is attached, and then disconnect the
cable
2
.
4. Lift the board straight up to remove it
3
.
5. Release the ZIF connector
4
on the LED board to which the
LED board cable is attached and disconnect the cable
5
.
6. Remove the LED board actuator
6
from the notebook.
Removing the LED Board
Reverse the above procedure to install the LED board.