Cub Cadet RZT S 42 RZT S 42 Operator's Manual - Page 11

Adjusting the Seat To adjust the position of the seat, lift the seat adjustment lever up. Slide the seat forward or rearward to the desired position; then release the adjustment lever. Make sure seat is locked into position before operating the tractor. See Figure 3-6. 3. Install the discharge chute deflector using the carriage bolts, push nuts and flange lock nuts as shown in Figure 3-8 and securely tighten the hardware. 50" Deck Shown Flange Lock Nuts Discharge Chute Deflector Push Nuts Carriage Bolts Figure 3-6 Lower Deck Discharge Chute Deflector WARNING! Never operate the mower deck without the chute deflector installed and in the down position. The discharge chute deflector must be installed before operating the mower. 1. Remove the keys that are attached with a zip tie to the chute bracket. 2. Remove the flange lock nuts from the deck. Do not remove the push nuts or carriage bolts, leaving them in place will aid in installing the chute. See Figure 3-7. 50" Deck Shown Flange Lock Nuts Figure 3-8 Push Nuts Carriage Bolts Figure 3-7 Section 3 - Assembly & Set-Up 11