Cub Cadet RZT S 42 RZT S 42 Operator's Manual - Page 13
Controls & Features - reverse pto bypass
View all Cub Cadet RZT S 42 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Controls & Features 4 Brake Pedal Steering Wheel Seat Adjustment Lever Fuel Tank Cap Forward Drive Pedal Reverse Drive Pedal Parking Brake/Cruise Control Lever Deck Lift Handle Deck Height Index Throttle/Choke Control PTO Knob Hour Meter/Indicator Panel Cup Holder Ignition Switch Storage Tray Transmission Bypass Valves Transmission Bypass Valves NOTE: References to LEFT, RIGHT, FRONT, and REAR indicate that position on the tractor when facing forward while seated in the operator's seat. Deck Height Index The deck height index consists of eight index notches located on the front/right of the console. Each notch LO corresponds to a 1⁄2" change in the deck height position 1 ranging from 1-1⁄2" at the lowest notch to 4" at the 2 highest notch. 3 Deck Lift Handle 4 The deck lift handle is located on the front/right of the 5 console, and is used to raise and lower the mower deck. 6 Pull the handle to the left out of the index notch and push 7 downward to lower the deck, or pull upward to raise the deck. When the desired height is attained, move the lift 8 handle to the right until fully in the index notch. HI DECK HEIGHT Ignition Switch The ignition switch is located on the LH console to the right of the operator's seat. The ignition switch has three positions as follows: STOP - The engine and electrical system is turned off. RUN - The tractor electrical system is energized. START - The starter motor will turn over the engine. Release the key immediately when the engine starts NOTE: To prevent accidental starting and/or battery discharge, remove the key from the ignition switch when the tractor is not in use. 13