D-Link DCS-2000 Product Manual - Page 6
Connections - support
View all D-Link DCS-2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Connections DC Power Connector Reset Button Ethernet Cable Connector I/O Connector Ethernet Cable Connector The DCS-2000 back panel features an RJ-45 connector for connections to 10Base-T Ethernet cabling or 100Base-TX Fast Ethernet cabling. This network port supports the NWay protocol, allowing the Internet Camera to automatically detect or negotiate the transmission speed of the network. The Ethernet cable included with the DCS-2000 Internet Camera is a Category 5 "straight through" cable. This is the recommended cable type when the camera is connected to a 100 Mbps Fast Ethernet network hub or switch. DC Power Connector The DC power input connector is located on the DCS-2000 Internet Camera's back panel and is labeled DC 12V with a single socket to supply power to the Internet Camera. Reset Button Reset will be initiated when the reset button is pressed once and held until the Power LED flashes through its cycle twice. Factory reset will be initiated when the reset button is pressed continuously for 5 seconds or when the Power LED changes from green to red for 2 cycles. (For example you will see the LED turn to red twice, release the reset button when the LED turns red the second time). The Power LED will begin to flash indicating that the Internet Camera's settings are reverting back to the factory settings, then turn back to green. To reset the camera, press the reset button once, and the LED will flash to orange. 6