D-Link DCS-6113 Product Manual - Page 48

Configuration Disconnect: If you want to break off the current connections, please select them and click this button. Please note that those selected connections will only be disconnected temporarily and will automatically try to re-link again (IE Explore or Quick Time Player). Enable Access List Filtering: Select this item and click Save if you want to enable the access list filtering function. Filter Type Select Allow or Deny as the filter type. If you choose Allow Type, only those clients whose IP addresses are on the Access List below can access the camera, and the others cannot access. On the contrary, if you choose Deny Type, those clients whose IP addresses are on the Access List below will not be allowed to access the camera, and the others can access. Filter Then you can add a rule to the following Access List. Please note that the IPv6 access list column will not be displayed unless you enable IPv6 on the Network page. For more information about IPv6 Setting, please refer to Enable IPv6 for detailed information. There are three types of rules: Single: This rule allows the user to add an IP address to the Allowed/Denied list. Network: This rule allows the user to assign a network address and corresponding subnet mask to the Allow/Deny List. Range: This rule allows the user to assign a range of IP addresses to the Allow/Deny List (This rule is only applied to IPv4). Administrator IP address Always allow the IP address to access this device: You can select this item and add the Administrator's IP address in this field to make sure the Administrator can always connect to the device. D-Link DCS-6112 /6113 User Manual 48