D-Link DFL-260E User Manual for DFL-260E - Page 461
add UserAuthRule AuthSource=Local, name=L2TP_Auth
View all D-Link DFL-260E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 461 highlights
9.5.2. L2TP Servers Chapter 9. VPN • Dynamically add route to the remote network when a tunnel is established 9. Click OK Now it is time to setup the L2TP Server. The inner IP address should be a part of the network which the clients are assigned IP addresses from, in this lan_ip. The outer interface filter is the interface that the L2TP server will accept connections on, this will be the earlier created l2tp_ipsec. ProxyARP also needs to be configured for the IPs used by the L2TP Clients. C. Setup the L2TP Tunnel: Command-Line Interface gw-world:/> add Interface L2TPServer l2tp_tunnel IP=lan_ip Interface=l2tp_ipsec ServerIP=wan_ip IPPool=l2tp_pool TunnelProtocol=L2TP AllowedRoutes=all-nets ProxyARPInterfaces=lan Web Interface 1. Go to: Interfaces > L2TP Servers > Add > L2TPServer 2. Enter a name for the L2TP tunnel, for example l2tp_tunnel 3. Now enter: • Inner IP Address: lan_ip • Tunnel Protocol: L2TP • Outer Interface Filter: l2tp_ipsec • Server IP: wan_ip 4. Under the PPP Parameters tab, check the Use User Authentication Rules control 5. Select l2tp_pool in the IP Pool control 6. Under the Add Route tab, select all-nets in the Allowed Networks control 7. In the ProxyARP control, select the lan interface 8. Click OK In order to authenticate the users using the L2TP tunnel, a user authentication rule needs to be configured. D. Next will be setting up the authentication rules: Command-Line Interface gw-world:/> add UserAuthRule AuthSource=Local Interface=l2tp_tunnel OriginatorIP=all-nets LocalUserDB=UserDB agent=PPP TerminatorIP=wan_ip name=L2TP_Auth Web Interface 1. Go to: User Authentication > User Authentication Rules > Add > UserAuthRule 2. Enter a suitable name for the rule, for example L2TP_Auth 3. Now enter: • Agent: PPP 461