D-Link DFL-260E User Manual for DFL-260E - Page 78

2.4.4. Memory Monitoring Settings Chapter 2. Management and Maintenance displayed next to the sensor in the output from the hwm command. Controlling the Event Sending Frequency The maximum frequency of log event generation when hardware monitoring values fall outside their preset range can be limited using the AlarmRepeatInterval setting in the LogSettings object. This setting is used because the monitored values are continuous. For example, to change the interval from the default of 60 seconds to a new value of 900 seconds, use the CLI command: gw-world:/> set Settings LogSettings AlarmRepeatInterval=900 This means that a new event message must now wait for 900 seconds after the previous one has been sent. All the options for LogSettings can be found in Section 2.2.8, "Advanced Log Settings". 2.4.4. Memory Monitoring Settings The System > Hardware Monitoring section of the Web Interface provides the administrator with a number of settings related to the monitoring of available memory. These are: Memory Poll Interval Memory polling interval which is the delay in minutes between readings of memory values. Minimum 1, Maximum 200. Default: 15 minutes Memory Use Percentage True if the memory monitor uses a percentage as the unit for monitoring, False if megabytes are used. Applies to Alert Level, Critical Level and Warning Level. Default: True Memory Log Repetition Should we send a log message for each poll result that is in the Alert, Critical or Warning level, or should we only send when a new level is reached. If True, a message is sent each time Memory Poll Interval is triggered. If False, a message is sent when a value goes from one level to another. Default: False Alert Level Generate an Alert log message if free memory is below this number of bytes. Disable by setting to 0. Maximum value is 10,000. Default: 0 Critical Level 78