Dell Latitude D610 Service Manual - Page 33

Back to Contents Page Speaker Assembly Dell™ Latitude™ D610 Service Manual Removing the Speaker Assembly Installing the Speaker Assembly CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide. NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer. Removing the Speaker Assembly 1. Follow the instructions in "Preparing to Work Inside the Computer." 2. Remove the center control cover (see "Removing the Center Control Cover"). 3. Remove the keyboard (see "Removing the Keyboard"). 4. Remove the display assembly (see "Removing the Display Assembly"). 5. Remove the palm rest (see "Removing the Palm Rest"). 6. Disconnect the speaker cable from the speaker connector on the system board. NOTICE: Handle the speaker assembly with care to avoid damaging it. 7. Remove the two M2.5 x 5-mm screws (one on each side) from the speaker assembly. 8. Remove the speaker assembly by pulling it straight up and out of the computer base. 1 speaker assembly 2 M2.5 x 5-mm screws (2) 3 speaker cable 4 speaker connector on system board Installing the Speaker Assembly 1. Slide the speaker assembly over the notch located in the center of the computer base. 2. Replace the two M2.5 x 5-mm screws (one on each side) on the speaker assembly. 3. Reconnect the speaker cable to the speaker connector on the system board. Back to Contents Page