Dell Latitude D610 Service Manual - Page 46

Removing the Device if the Security Screw Is Not Installed, Removing the Device if the Security

Page 46 highlights

4. Replace the modem cover. Devices Your computer ships with an optical drive installed in the module bay. However, the device security screw is not installed in the optical drive but packaged separately. When you install your device in the module bay, you can install the device security screw. NOTICE: Insert devices into the module bay before you dock and turn on the computer. NOTE: You do not need to install the device security screw unless you want to secure the module inside the computer for security purposes. Removing the Device if the Security Screw Is Not Installed NOTICE: To prevent damage to devices, place them in a safe, dry place when they are not installed in the computer. Avoid pressing down on them or placing heavy objects on top of them. 1. Press the device latch release so that the latch release pops out. 1 device latch release 2. Pull the device by the latch release to remove the device from the module bay. Removing the Device if the Security Screw Is Installed 1. If the computer is connected to a docking device (docked), undock it. See the documentation that came with your docking device for instructions. NOTICE: To prevent damage to devices, place them in a safe, dry place when they are not installed in the computer. Avoid pressing down on them or placing heavy objects on top of them. 2. Close the display and turn the computer over. 3. Use a #1 Phillips screwdriver to remove the M2 x 3-mm screw from the bottom of the computer.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47

4.
Replace the modem cover.
Devices
Your computer ships with an optical drive installed in the module bay. However, the device security screw is not installed in the optical drive but packaged
separately. When you install your device in the module bay, you can install the device security screw.
Removing the Device if the Security Screw Is Not Installed
1.
Press the device latch release so that the latch release pops out.
2.
Pull the device by the latch release to remove the device from the module bay.
Removing the Device if the Security Screw Is Installed
1.
If the computer is connected to a docking device (docked), undock it. See the documentation that came with your docking device for instructions.
2.
Close the display and turn the computer over.
3.
Use a #1 Phillips screwdriver to remove the M2 x 3-mm screw from the bottom of the computer.
NOTICE:
Insert devices into the module bay before you dock and turn on the computer.
NOTE:
You do not need to install the device security screw unless you want to secure the module inside the computer for security purposes.
NOTICE:
To prevent damage to devices, place them in a safe, dry place when they are not installed in the computer. Avoid pressing down on them or
placing heavy objects on top of them.
1
device latch release
NOTICE:
To prevent damage to devices, place them in a safe, dry place when they are not installed in the computer. Avoid pressing down on them or
placing heavy objects on top of them.