Dell PowerEdge XL 5133-4 Dell PowerEdge M I/O Aggregator Getting Started Guide - Page 23

2 At the EXEC mode prompt, enter enable. At the EXEC Privilege prompt, enter configure to reach the configuration command mode. FTOS> enable FTOS# configure FTOS(conf)# 3 (CLI only) At the configuration mode prompt, enter the hostname name command to configure a hostname for the Aggregator, where name is a text string of up to 20 alphanumeric characters. Host names must start with a letter and end with a letter or number. Characters within the string can be letters, numbers, and hyphens. FTOS(conf)# hostname Aggregator1 FTOS(conf)# 4 (CMC-supported) To reconfigure the default username and password, enter the username name password password command, where name is a string of up to 63 alphanumeric characters and password is a string of up to 32 characters. Both values are case sensitive; spaces are supported. FTOS(conf)# username admin password dellAgg1 FTOS(conf)# 5 (CLI only) At power up, the default VLAN for all ports is VLAN 1. To reconfigure the default VLAN, enter the default vlan vlan-id command; for example: FTOS(conf)# default vlan 3 6 (CMC-supported) To reconfigure the SNMP community name used for read-only management access to the switch, enter the snmp-server community name ro command, where name is a text string of up to 20 alphanumeric characters and ro specifies read-only permission. FTOS(conf)# snmp-server community dellSNMP ro 7 (CMC-supported) By default, the IP address and subnet mask of the out- of-band management interface used for remote SNMP or Telnet access is assigned by a DHCP server. You can reconfigure the default setting by specifying an IP address with the following commands: interface ManagementEthernet slot/port, where is slot is 0-1 and port is 0. ip address ip-address/mask, where ip-address is in dotted-decimal format (A.B.C.D) and mask is a subnet mask in /prefix-length format (/xx). no shutdown enables the interface. Installing and Configuring the Aggregator 23