Dell PowerEdge XL 5133-4 Dell PowerEdge M I/O Aggregator Getting Started Guide - Page 24

For example: FTOS(conf)# interface ManagementEthernet 1/0 FTOS(conf-if-ma-1/0)# ip address 128.0.0.1/24 FTOS(conf-if-ma-1/0)# no shutdown 8 (CMC-supported) To reconfigure the default route used by the out-ofband interface to access the Aggregator from a remote network, enter the management route subnet/mask managementethernet command, where subnet/mask is an IP address in dotted decimal format (A.B.C.D) and a subnet mask that defines the out-of-band management network. FTOS(conf)# management route 10.0.0.0/24 9 (CLI only) By default, the IP address of the default VLAN used to access the switch from an in-band routing interface is assigned by a DHCP server. You can reconfigure the default setting by specifying an IP address with the ip address ip-address/mask command: FTOS(conf)# interface vlan 1 FTOS(conf-if-vl-1)# ip address 10.1.1.4/24 10 (CLI only) To reconfigure the default route used by the in-band management interface (default VLAN) used to access the Aggregator from a remote network, enter the ip route subnet/mask vlan 1 command, where subnet/mask is an IP address in dotted decimal format (A.B.C.D) and a subnet mask that defines the in-band management network. FTOS(conf)# ip route 10.1.1.0/24 vlan 1 11 (CLI only) By default, broadcast storm control is enabled on an Aggregator to limit unregistered unicast, multicast, and broadcast packets. To disable storm control, enter the following command: FTOS(conf)# no io-aggregator broadcast storm-control 12 (CLI only) By default, IGMP multicast flooding is enabled on an Aggregator. To disable multicast flooding to send unregistered multicast packets only to interested hosts in a VLAN, enter the following command: FTOS(conf)# no ip igmp snooping flood 24 Installing and Configuring the Aggregator