Denon AVR 2809CI Owners Manual - English - Page 58

Getting Started Connections Setup Playback Remote Control Multi-zone Information Troubleshooting Specifications Symbols used to indicate buttons in this manual Button located on both the main unit and the remote control unit Button only on the main unit Button only on the remote control unit BUTTON [BUTTON] Searching Categories 1 Press o p. SR001 Hits 1 CAT : Pops Channel category 2 Use o p to select the category, to use ui to select the desired channel. • Channels under Parental Lock cannot be tuned in by performing Tuning Up/Down or by category search. • Channels stored in preset memory can be tuned in by the preset channel select operation, even if Parental Lock is applied. • When a channel to which Parental Lock is applied is being played, Parental Lock for that channel is cancelled by performing Step 2. • See "Edit Lock Cord" (vpage 55) for the method of changing Parental Lock Cord. • You can also set "Parental Lock" from the menu. (vpage 55). ENTER SIRIUS [ SAT TU] ( mode) [SEARCH] uiop [ENTER] [SAT TU1] (AMP mode) [NUMBER (1 ~ 8)]  uiop iPod [ iPod] [8], [9], [6], [7], [1], [2] [SEARCH] [POWER OFF] uiop ENTER [CHANNEL + -] [iPod] (AMP mode) Accessing SIRIUS Satellite Radio Channels Directly 1 Press [SEARCH]. 2 Press [NUMBER (1 ~ 8)] to input the channel. Example: Accessing channel "SR123": [1] → [2] → [3] b If no button is pressed within several seconds, the channel automatically switches to the one whose number has been input. 3 Press [ENTER] to set that channel. Reception switches to the selected channel. • "UPDATING" is displayed while the encording code is being updated. • "SIRIUS UPDATING" is displayed when updating SIRIUS tuner firmware. • Refer to "Troubleshooting" - "SIRIUS Satellite Radio" regarding other messages (vpage 81). Parental Lock 1 Tune to the channel you want to lock. 2 Press [ENTER] for at least 3 seconds. "Code: [ ]" is displayed. 3 Enter the 4-digit lock code using uio p. When you enter the correct code, the corresponding channel is locked. 4 Press [ENTER]. iPod® Playback The music on an iPod can be played by using the control dock for iPod (ASD-1R, ASD-11R, ASD-3N or ASD-3W sold separately). The operation can also be performed using the buttons on the main unit or main remote control unit while watching the menus. iPod is a trademark of Apple Inc., registered in the U.S. and other countries. b The iPod may only be used to copy or play contents that are not copyrighted or contents for which copying or playback is legally permitted for your private use as an individual. Be sure to comply with applicable copyright legislation. Basic Operation 1 Make the necessary preparations. qSet the iPod in the DENON control dock for iPod. (vSee the control dock for iPod's operating instructions.) wAssign the control dock for iPod's input. The input for the control dock for iPod is assigned to VCR by default. MENU : "Input Setup" - "Assign" - "iPod Dock" (vpage 39) 2 Either turn or press [iPod] to select the input source assigned in step 1-w above. OK to disconnect. (iPod screen) b If the screens above are not displayed, the iPod may not be properly connected. Try connecting again.