Dewalt DWMIIIFS Instruction Manual - Page 3
SAFETY INSTRUCTIONS, Safety Instructions - Air Supply and Connections - loading
View all Dewalt DWMIIIFS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
INTENDED USE This DWMIIIFS Flooring Tool is intended for use by construction professionals for installing unfinished hardwood flooring. Precautions Regarding Use of this Tool to Install Prefinished Flooring It may also be used to install prefinished wood flooring materials, however precautions must be taken to assure that the finish will not be damaged by the tool. Before using the tool on prefinished material, test a sample section to assure that the tool and installation technique does not leave marks on the finish. This procedure must be followed for every installation due to variations in flooring materials and condition of the tool. Do not discharge fasteners into open air, concrete, stone, or any other material too hard for the fastener to penetrate. Use of this tool by inexperienced operators must be supervised. WARNING: Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. Some examples of these chemicals are lead from lead-based paints, crystalline silica from bricks and cement and other masonry products , and arsenic and chromium from chemically treated lumber. Your risk from exposure varies, depending on how often you do this type of work. To reduce your exposure to these chemicals, work in a well-ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles." SAFETY INSTRUCTIONS WARNING: EYE PROTECTION which conforms to ANSI specifications and provides protection against flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator and others in the work area when connecting to air supply, loading, operating or servicing this tool. Eye protection is required to guard against flying fasteners and debris, which could cause severe eye injury. The employer and/or user must ensure that proper eye protection is worn. Eye protection equipment must conform to the requirements of the American National Standards Institute, ANSI CAN/CSA Z94.3 and provide both frontal and side protection. NOTE: Non-side shielded spectacles and face shields alone do not provide adequate protection. CAUTION: Additional Safety Protection will be required in some environments. For example, the working area may include exposure to noise level which can lead to hearing damage. The employer and user must ensure that any necessary hearing protection is provided and used by the operator and others in the work area. Some environments will require the use of head protection equipment. When required, the employer and user must ensure that head protection conforming to ANSI CAN/CSA Z89.1 is used. Safety Instructions - Air Supply and Connections WARNING: Do not use oxygen, combustible gases, or bottled gases as a power source for this tool as tool may explode, possibly causing injury. WARNING: Do not use supply sources which can potentially exceed 200 p.s.i.g. (14kg/cm2 ) as tool may burst, possibly causing injury. WARNING: The connector on the tool must not hold pressure when air supply is disconnected. If a wrong fitting is used, the tool can remain charged with air after disconnecting and thus will be able to drive a fastener even after the air line is disconnected possibly causing injury. 3- ENG