Dewalt DWMIIIFS Instruction Manual - Page 4

WARNING: Always disconnect air supply: 1.) Before making adjustments; 2.) When servicing the tool; 3.) When clearing a jam; 4.) When tool is not in use; 5.) When moving to a different work area, as accidental actuation may­­occur, possibly causing injury. Safety Instructions - Loading Tool WARNING: When loading tool: 1.) Never place a hand or any part of body in fastener discharge area of tool; 2.) Never point tool at anyone; possibly causing injury. Safety Instructions - Operation WARNING: Always handle the tool with care: 1.) Never engage in horseplay; 2.) Keep others a safe distance from the tool while tool is in operation as accidental actuation may occur, possibly causing injury. WARNING: Keep hands and body away from the discharge area of the tool. A contact arm tool may bounce from the recoil of driving a fastener and an unwanted second fastener may be driven possibly causing injury. WARNING: Check operation of the contact arm mechanism frequently. Do not use the tool if the arm is not working correctly as accidental driving of a fastener may result. Do not interfere with the proper operation of the contact arm mechanism. WARNING: Do not drive fasteners on top of other fasteners or with the tool at an overly steep angle as this may cause deflection of fasteners which could cause injury. WARNING: Do not drive fasteners close to the edge of the work piece as the wood may split, allowing the fastener to be deflected possibly causing injury. WARNING: This nailer produces SPARKS during operation. NEVER use the nailer near flammable substances, gases or vapors including lacquer, paint, benzine, thinner, gasoline, adhesives, mastics, glues or any other material that is -- or the vapors, fumes or byproducts of which are -- flammable, combustible or explosive. Using the nailer in any such environment could cause an EXPLOSION resulting in personal injury or death to user and bystanders. Safety Instructions - Maintaining the Tool WARNING: When working on air tools note the warnings in this manual and use extra care when evaluating problem tools. TOOL SPECIFICATIONS All dimensions in inches unless otherwise specified MODEL LENGTH HEIGHT WIDTH WEIGHT DWMIIIFS 17-1/4" (438 mm) 11-1/2" (292 mm) 3-1/8" (80 mm) 11.2 lbs (5.1 kg) FASTENER SPECIFICATIONS MODEL FASTENER CROWN WIDTH DWMIIIFS DWCS1500 or 1/2" (13 mm) BCS1500 GAUGE 15-1/2 Ga. FASTENER RANGE 2" (50 mm) Tool Air Fitting This tool uses a 3/8" N.P.T. male plug. The inside diameter should be .275" (7 mm) or larger. The fitting must be capable of discharging tool air pressure when disconnected from the air supply. 4- ENG