Epson PictureMate Show - PM 300 User's Guide - Page 73
Software Installation Problems, Print Quality Problems, saturation, absorption of ink, and quality.
View all Epson PictureMate Show - PM 300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Software Installation Problems ● Follow the instructions beginning on page 35 to install your software. Don't connect PictureMate to your computer until you are instructed to. ● Close other programs, including screen savers and virus protection software, and try installing again. ● Make sure your system meets the requirements listed in "System Requirements" on page 82. ● To print over a network, see "Set Up Network Printing" on page 78 for instructions. Print Quality Problems You see banding (light lines) in your prints. ● The print head may need cleaning. See page 65. ● Be sure to print with the glossy or whiter side of the paper face up. ● The photo cartridge may need replacing. See page 57. Your print is grainy. ● The print head may need aligning. See page 67. ● You may need to increase the image resolution; see your software documentation. Your print is blurry or smeared. ● Use PictureMate photo paper to ensure proper saturation, absorption of ink, and quality. ● Be sure to print with the glossy or whiter side of the paper face up. ● The print head may need cleaning. See page 65. ● The print head may need aligning. See page 67. ● Make sure your paper isn't damp or curled, or loaded face down (load it glossy or whiter side up). If it's damp or curled, load a new paper. ● Remove each photo from the output tray after printing. Let each photo sit for a minute before handling it. Your print is faint or has gaps in the image. ● The print head may need cleaning. See page 65. ● The photo cartridge may be old or low. See page 56 to replace it. 73