Epson WorkForce 600 Network Installation Guide - Page 3

Wireless Network Installation, Connect the Ethernet Cable - all in one printer

Get Epson WorkForce 600 - All-in-One Printer PDF manuals and user guides View all Epson WorkForce 600 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 3 highlights

Wireless Network Installation To add the printer to your wireless network, you need to know the name (SSID) of your wireless network. If it has security enabled, you also need to know the WEP key or passphrase. Write down the SSID and WEP key or passphrase below: ■ Network name (SSID WEP key or passphrase Note: If the WEP key is either 5 or 13 characters, it's ASCII. If the WEP key is either 10 or 26 characters, it's hexadecimal. The default WEP key is usually 1. If your passphrase contains upper- or lowercase letters, be sure to note it correctly. The printer supports the following wireless security modes: WEP 64, WEP 128, and WPA-PSK. If you don't know your wireless network name (SSID) or WEP key or passphrase, contact the person who set up your wireless network before you begin. Connect the Ethernet Cable Note: This is a temporary connection used to configure the printer. You will be prompted to remove the cable when configuration is complete. 1. Connect an Ethernet network cable to the LAN (10/100) port on your printer. Wireless Network Installation 3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
Wireless Network Installation
3
Wireless Network Installation
To add the printer to your wireless network, you need to know the name (SSID)
of your wireless network. If it has security enabled, you also need to know the
WEP key or passphrase. Write down the SSID and WEP key or passphrase below:
■
Network name (SSID): _________________________________________
■
WEP key or passphrase: _________________________________________
Note:
If the WEP key is either 5 or 13 characters, it’s ASCII. If the WEP key is either 10 or 26
characters, it’s hexadecimal. The default WEP key is usually 1.
If your passphrase contains upper- or lowercase letters, be sure to note it correctly.
The printer supports the following wireless security modes: WEP 64, WEP 128, and
WPA-PSK.
If you don’t know your wireless network name (SSID) or WEP key or passphrase,
contact the person who set up your wireless network before you begin.
Connect the Ethernet Cable
Note:
This is a temporary connection used to configure the printer. You will be prompted to
remove the cable when configuration is complete.
1.
Connect an Ethernet network cable to the
LAN
(
10/100)
port on your printer.