Fujitsu 5530C2 Operator's Guide - Page 63
Scanning Documents of Different Widths, SCANNING VARIOUS TYPES OF DOCUMENTS - fi sheet fed scanner
UPC - 097564307201
View all Fujitsu 5530C2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
2.2 Scanning Documents of Different Widths 2.2 Scanning Documents of Different Widths When you scan documents of different widths at one time from the ADF, some documents that are small in paper size may be skewed or may not be fed into the scanner. It is recommended that only documents of the same width be scanned at one time. In the case where you have to scan documents of different widths together, scan them, following the procedure below. 1. To prevent images from skewing, select [Automatic Page Size Detection] from the [Automatic Size and Skew Detection] drop-down list. (For details, refer to "2.9 2 Correcting Skew" on page 71.) 2. Center all documents as shown in the figure below. SCANNING VARIOUS TYPES OF DOCUMENTS 3. Place the documents on the ADF paper chute, and then adjust the side guides so that they lightly touch the widest sheets of paper. ATTENTION When placing the stack of documents on the scanner, make sure that all documents are directly under the pick roller. Off-center documents, which are not under the pick roller, cannot be fed into the scanner. 4. Scan the documents. For information about how to scan documents, refer to section "1.5 How to Use ScandAll PRO" on page 29. fi-5530C2 Image Scanner Operator's Guide 47