Fujitsu S300M Operator's Guide - Page 35
Connecting the ScanSnap to Your Computer, Connecting the cable
UPC - 097564307355
View all Fujitsu S300M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
2.2 Connecting the ScanSnap to Your Computer 2.2 Connecting the ScanSnap to Your Computer When the installation of the above programs is complete, connect the ScanSnap to your computer. ATTENTION Be sure to install the supplied programs, and then restart your computer before connecting the ScanSnap to your computer with cables. (For details about the installation, refer to "2.1 Installing ScanSnap" (page 6).) ■ Connecting the cable 2 Connecting ScanSnap Connect the ScanSnap to a power supply in either of two ways below: First, connect to a power supply, and then connect to your computer with the USB cable. Power source Use the following cable: See: Power outlet Power cable (When always operating the ScanSnap at the same regular place where it can be fed power from a power outlet) The power cable is a combination of the AC adapter and AC cable. "When connecting with the power cable:" (page 16) Computer (When using the ScanSnap at a place where it reaches no power outlet, or when carrying the ScanSnap together with your laptop computer around and operating at a place where no power outlet is available) USB bus power cable "When connecting with the USB bus power cable:" (page 17) CAUTION Use only the AC cable and AC adapter (power cable) below: Otherwise, a failure may be caused. • Manufacturer: LEI • Model No.: NU13-1072166-I3 ScanSnap S300M Operator's Guide 15