Fujitsu S510M Operator's Guide - Page 179
Replacing the Pick Roller, ScanSnap S500 Operator's Guide, Remove the pick roller with its shaft.
UPC - 097564307324
View all Fujitsu S510M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 179 highlights
7.3 Replacing the Pick Roller 6. Remove the pick roller with its shaft. Slightly pull up the left part of the Pick roller shaft (about 5mm), move it towards the left side, and then raise it to remove from the scanner. 7 Replacing Consumables and Carrier Sheet Pick roller shaft Pick roller ATTENTION If the around the pick roller is dirty by paper-powder, it may cause a scanning error. Remove the dirt using a dry cloth with dollop of Cleaner F1. * Don't use water, mild detergent or air-spray. 7. Remove the pick roller from its shaft. Pull out the shaft from the pick roller while lifting up its tab. Tab Pick roller Shaft ScanSnap S500 Operator's Guide 161
7.3 Replacing the Pick Roller
ScanSnap S500 Operator's Guide
161
Replacing Consumables and Carrier Sheet
7
6.
Remove the pick roller with its shaft.
Slightly pull up the left part of the Pick roller shaft (about 5mm), move it towards the left
side, and then raise it to remove from the scanner.
7.
Remove the pick roller from its shaft.
Pull out the shaft from the pick roller while lifting up its tab.
ATTENTION
If the around the pick roller is dirty by paper-powder, it may cause a scanning
error. Remove the dirt using a dry cloth with dollop of Cleaner F1.
* Don't use water, mild detergent or air-spray.
Pick roller shaft
Pick roller
Shaft
Tab
Pick roller