Gateway 510 Gateway 510-Series Computer User's Guide - Page 204
Reconnect the drive cables using your notes from, latch locks the drive into place.
View all Gateway 510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 204 highlights
Chapter 13: Upgrading Your Computer 4 If you are adding a new drive, remove the drive bay cover from the drive bay where you want to install the new drive. - OR If you are replacing a drive, lift the drive release latch up and slide the drive forward and out of the drive bay. 5 Set the drive jumpers, if necessary. See the drive documentation for further instructions. 6 Slide the new drive into the drive bay. Push firmly until the drive release latch locks the drive into place. 7 Reconnect the drive cables using your notes from Step 3. The red-striped edge of the data ribbon cable indicates Pin 1 and corresponds with Pin 1 on the drive (typically on the side closest to the power supply connection). See the drive documentation for further instructions. 8 Close the case by following the instructions in "Closing the case" on page 192. 196 www.gateway.com