GE GFDS140GDWW Owners Manual - Page 12
Step-by-step Instructions Cont.
View all GE GFDS140GDWW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Reversing the door swing. STEP-BY-STEP INSTRUCTIONS (cont.) Remove Door Assembly 2. Open the door to approximately 130 degrees. Remove Top Screw 3. Remove the 4 screws starting from the bottom to the top. Make sure the door is supported while removing the screws. 4. Loosen the top screw as shown. Unhook the door by lifting and pulling. 8-#10 Tapping Screws 2 Beauty Buttons 5. Place the door on a soft protected flat surface so the inner door faces upward (door resting on handle side). Remove the 8 tapping screws located around the perimeter of the door outlining the gasket. Remove the 4 machine screws. 4-# 8 Machine Tapping Screws Outer Door Assembly Remove Hinge and Cover IMPORTANT: Note the location of the hinge (left or right) before removing. 6. With the screws removed, turn the door over and separate the outer door assembly and hinge cover of the door from the door frame and set aside. Hinge Assembly 12 Hinge Cover