GE GFDS140GDWW Owners Manual - Page 19

Before You Begin, For Your Safety, Minimum Clearance Other Than Alcove Or Closet, Installation,

Page 19 highlights

Stacking. GEAppliances.com BEFORE YOU BEGIN Read these instructions completely and carefully. „ IMPORTANT: Save these instructions for local electrical inspector's use. „ IMPORTANT: Observe all governing codes and ordinances. „ Note to Installer - Be sure to leave these instructions with the Consumer. „ Note to Consumer - Keep these instructions for future reference. „ Installation must be performed by a qualified installer. „ Proper installation is the responsibility of the installer. FOR YOUR SAFETY WARNING! „ Electric Shock Hazard. Disconnect power before installing. Failure to do so could result in serious injury or death. „ Potential Personal Injury. When stacking the dryer, more than two people are recommended to lift the dryer into position because of its weight and size. Failure to do so could result in personal injury or death. „ When stacking the dryer, avoid tipping and rupture of utility services. Dryer must be securely attached to the washer. DO NOT place the washer on top of the dryer. Failure to do so could result in personal injury/death or property damage. „ Mobile Home or Manufactured Home Installation - Stacking of a gas dryer is not permitted in a mobile home or manufactured home. MINIMUM CLEARANCE OTHER THAN ALCOVE OR CLOSET INSTALLATION Minimum clearance to combustible surfaces and for air opening are: 0s both sides, 1s front, and 3s rear. Consideration must be given to provide adequate clearance for installation and service. ALCOVE OR CLOSET INSTALLATION „ If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back. „ The dryer MUST be vented to the outdoors. Refer to dryer Installation Instructions for details. „ Minimum clearance between dryer cabinet and adjacent walls or other surfaces is: 0s either side 3s front 3s rear „ Minimum vertical space from floor to overhead cabinets, ceiling, etc. is 52s. „ Closet doors must be louvered or otherwise ventilated and must contain a minimum of 60 square inches of open area equally distributed. If the closet contains both a washer and a dryer, doors must contain a minimum of 120 square inches of open area equally distributed. 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60

19
Stacking.
GEAppliances.com
BEFORE YOU BEGIN
Read these instructions completely and carefully.
±
IMPORTANT:
Save these instructions for local
electrical inspector’s use.
±
IMPORTANT:
Observe all governing codes and
ordinances.
±
Note to Installer –
Be sure to leave these
instructions with the Consumer.
±
Note to Consumer –
Keep these instructions
for future reference.
±
Installation
must
be performed by a qualified
installer.
±
Proper installation is the responsibility
of the installer.
FOR YOUR SAFETY
WARNING!
±
Electric Shock Hazard. Disconnect power before
installing. Failure to do so could result in serious
injury or death.
±
Potential Personal Injury. When stacking the
dryer, more than two people are recommended
to lift the dryer into position because of its
weight and size. Failure to do so could result in
personal injury or death.
±
When stacking the dryer,
avoid tipping and
rupture of utility services. Dryer must be securely
attached to the washer. DO NOT place the
washer on top of the dryer. Failure to do so
could result in personal injury/death or property
damage.
±
Mobile Home or Manufactured Home Installation
– Stacking of a gas dryer is not permitted in a
mobile home or manufactured home.
MINIMUM CLEARANCE OTHER THAN ALCOVE OR CLOSET
INSTALLATION
Minimum clearance to combustible surfaces
and for air opening are: 0
s
both sides, 1
s
front, and
3
s
rear. Consideration must be given to provide
adequate clearance for installation and service.
ALCOVE OR CLOSET INSTALLATION
±
If your dryer is approved for installation
in an alcove or closet, it will be stated on
a label on the dryer back.
±
The dryer MUST be vented to the outdoors. Refer
to dryer Installation Instructions for details.
±
Minimum clearance between dryer cabinet and
adjacent walls or other surfaces is:
0
s
either side
3
s
front
3
s
rear
±
Minimum vertical space from floor to overhead
cabinets, ceiling, etc. is 52
s
.
±
Closet doors must be louvered or otherwise
ventilated and must contain a minimum
of 60 square inches of open area equally
distributed. If the closet contains both a washer
and a dryer, doors must contain a minimum
of 120 square inches of open area equally
distributed.