Genie SilentMax 1000 Owner's Manual - Page 17
Screw Drive, Belt/Chain Drive - how to install
View all Genie SilentMax 1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
6 Maintenance and Adjustments REGULAR MAINTENANCE (continued) • Screw drive models: Verify shuttle release lever is in ENGAGED (UP) position (pull release handle toward opener and let go) • Chain/belt drive models: Verify bullet is engaged to carriage. Pull/release cord down and back towards opener and let go. Screw Drive Opener Belt/Chain Drive Opener Disengaged Engaged Disengaged Engaged - Operate door using a remote or wall console. - Door will re-attach itself to carriage assembly. CORRECTIVE MAINTENANCE Changing Light Bulbs WARNING • Use extreme caution when working from a ladder or step stool. • When replacing light cover, make sure wires are not pinched or near moving parts. 1. Disconnect power to door opener. • Open powerhead light cover. • Remove light bulb(s). • Replace light bulb(s). - DO NOT use light bulbs with greater than 100 Watt rating, PowerLift® 900, GPower™ 900 require light bulbs of no more than 60 watts. Compact CFL's may also be used. - Close powerhead light cover. 2. Reconnect power to door opener. • Test light operation. Reset Open/Close Travel Limit Performing all eleven (11) Limits/Force setting steps (see pages 6-8) erases previous Limits/Force settings. Note: The opener will not close the door automatically unless the Safe-T-Beam® System is installed and Limits are programmed. Disengaging and Engaging Carriage/Bullet Screw Drive Opener Belt/Chain Drive Opener Disengaged Engaged Disengaged Engaged To engage bullet to carriage, pull the release handle down and toward the opener. To engage shuttle to carriage, pull down and toward the opener. To disengage shuttle from carriage, pull down on relaese hanfle. To disengage bullet from carriage, pull relaese handle down and toward the door. Remote Battery Replacement Replace remote battery with a CR 2032 coin cell battery. 1. Open remote case using a washer or coin that fits into the slot at top of remote. 2. Replace battery. 3. Align components and snap case closed. (continued next page) 17 G999-393 Manual-ScrewBeltChain-EN indd 17 7/13/12 10 17 AM