Genie SilentMax 1000 Owner's Manual - Page 8

3 Required Programming Wall Console / Overview This opener has a serial number sticker in which the serial numbers begin with 10 or higher. MODEL AC SR3 FCC ID: B8Q AC SR3 IC: 2 33A-CS 1D THE GENIE COMPANY Residential Door Operator 120V. 60HZ. 5A S/N:10XXXX XXXXXXX Wall consoles from other manufacturers may not work with openers of these serial number groups. Use only the wall console provided with this unit. Each wall console has three buttons. In your carton you will find one of the following wall consoles: Series II Wall Consoles with White Buttons Indicator Light Large white button will display Red when wall console is properly wired and Sure-Lock™ is OFF. When Sure-Lock™ is ON, this light is off Open/Close Button Use this button to open or close garage door. When Sure-Lock™ is ON, the Open/Close button will CLOSE the door only. Note: Constant button pressure in the CLOSE mode will override STB fault in the powerhead and close door. Independent Light Control Button Use this button to turn powerhead lights ON. Powerhead lighting will remain ON until this button is pressed again or a door action has been completed. Note: If opener has a Motion Detector sensor, it will keep powerhead lights ON as long as motion is detected. Sure-Lock™ Button When Sure-Lock™ is ON, the powerhead cannot be activated by the wall console or a remote. • Press and release (or until red light goes off) to activate Sure-Lock™. • Press and release to turn Sure-Lock™ OFF. Open/Close Button Opens and closes door from inside garage. Indicator Light -Red indicator backlight is ON. -When Sure-Lock™ is ON, the indicator light is OFF To powerhead Sure-Lock™ Button - LOCK disables controls after door is completely closed. W B/W - UNLOCK allows controls to work normally. Independent Light Control Button Controls door opener lights from inside garage. 8 Series III Wall Consoles with Black Buttons Indicator Light Indicator light will display Red when wall console is properly wired and Sure-Lock™ is OFF. When Sure-Lock™ is ON, indicator light flashes. Open/Close Button Use this button to open or close garage door. When Sure-Lock™ is ON, the Open/Close button will CLOSE the door only. Note: Constant button pressure in the CLOSE mode will override STB fault in the powerhead and close door. Independent Light Control Button Use this button to turn powerhead lights ON. Powerhead lighting will remain ON until this button is pressed again or a door action has been completed. Note: If opener has a Motion Detector sensor, it will keep powerhead lights ON as long as motion is detected. Sure-Lock™ Button When Sure-Lock™ is ON, the powerhead cannot be activated by the wall console or a remote. • Press and hold for 5 seconds (or until Indicator Light flashes) to activate Sure-Lock™. • Press and release to turn Sure-Lock™ OFF. Open/Close Button Opens and closes door from inside garage. Indicator Light -Red indicator light is always ON. -When Sure-Lock™ is ON, the indicator light flashes. To powerhead Sure-Lock™ Button - LOCK disables controls after door is completely W closed. B/W - UNLOCK allows controls to work normally. Independent Light Control Button Controls door opener lights from inside garage. TIP FROM STBs OM STB FROM WALL CONSOLE FROM STBs FROM WALL CONSOLE STB BWC IWC NOT NOT USED USED STB BWC IWC G999-393 Manual-ScrewBeltChain-EN indd 8 7/13/12 10 17 AM