Gigabyte GA-X58A-UD3R Manual - Page 28
SATA2_0/1/2/3/4/5 SATA 3Gb/s Connectors, Controlled by ICH10R, Controlled by GIGABYTE SATA2, RAID 1 - raid controller
UPC - 818313009760
View all Gigabyte GA-X58A-UD3R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
9) SATA2_0/1/2/3/4/5 (SATA 3Gb/s Connectors, Controlled by ICH10R) The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s stan- dard. Each SATA connector supports a single SATA device. The ICH10R controller supports RAID 0, RAID 1, RAID 5, and RAID 10. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array. G.QBOFM G.QBOFM G.QBOFM Pin No. Definition SATA2_5 7 7 SATA2_4 SATA2_3 SATA2_2 SATA2_1 1 12 3 1 4 SATA2_0 5 GND TXP TXN GND RXN 6 RXP 7 GND 10) GSATA2_8/9 (SATA 3Gb/s Connectors, Controlled by GIGABYTE SATA2) The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The GIGABYTE SATA2 controller supports RAID 0, RAID 1, and JBOD. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array. G.QBOFM Pin No. Definition GSATA2_9 1 GND 7 1 2 TXP 7 1 GSATA2_8 3 TXN 4 GND 5 RXN 6 RXP 7 GND Please connect the L-shaped end of the SATA 3Gb/s cable to your SATA hard drive. • A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives are to be used, the total number of hard drives must be an even number. • A RAID 5 configuration requires at least three hard drives. (The total number of hard drives does not have to be an even number.) • A RAID 10 configuration requires at least four hard drives and the total number of hard drives must be an even number. Hardware Installation - 28 -