Haier HT18TS45SW HT18TW10SW - Page 11
Door Handle Installation Cont.
View all Haier HT18TS45SW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
ENGLISH DOOR HANDLE INSTALLATION CONT. DOOR HANDLE INSTALLATION For refrigerators without a mounting screw installed on the face of both doors: Remove both handles from the freezer compartment and the screws and handle trim pieces from the parts-included bag. FREEZER DOOR HANDLE 1. Mount the tapered end of the handle to the door face using the enclosed screw. Do not use the screw hole closest to the center of the handle. Fig. 3 2. Attach the flat end of the handle to the underside of the door using the enclosed screws. Fig. 4 REFRIGERATOR DOOR HANDLE 1. Mount the tapered end of the handle to the door face using the enclosed screw. (Fig. 3) Do not use the screw hole closest to the center of the handle. 2. Attach the flat end of the handle to the top of the door using the enclosed screws. (Fig. 4) 3. Insert tab on handle trim cover into slot in handle then press firmly onto handle. (Fig. 5) 4. If re-installing handles after reversing the door swing, remove the screw hole plug from the parts-included bag and place it in the handle-mounting screw hole on the face of the refrigerator door. 5. The name badge can be removed by using a putty knife or flat head screwdriver to pry the badge off the door face, being careful not to damage the finish. Any residue left on the face of the door from the badge should be removed by using Goo Gone© or WD-40©. Be sure to follow the manufacturer's instructions when using these products. Do not use any abrasives or scouring pads to remove the residue. An extra logo badge is provided in the partsincluded bag with your refrigerator. That badge can be used to cover the handle-mounting screw hole on the face of the freezer door. 3. Insert tab on handle trim cover into slot in handle and then press firmly onto handle. Fig. 5 PAGE 9 • SET UP & USE