Haier HT18TS45SW HT18TW10SW - Page 13
Reversing The Door Cont.
View all Haier HT18TS45SW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
ENGLISH REVERSING THE DOOR CONT. 10. Remove the bottom hinge by unscrewing the bolts mounting it to the cabinet. NOTE: It is easier to remove and re-install the bottom hinge pin while the hinge is itself is still attached to the cabinet. Fig. 12 4. Remove the top thimble cover on the hinge side of the refrigerator door and relocate it to the opposite thimble hole. Use both hands to mount the door on bottom hinge pin, making sure the pin goes fully into the bottom thimble hole. When the top thimble hole is aligned with the hole in the center hinge, place the hinge pin into the hole, threaded end down, and tighten. Fig. 15 RE-INSTALLING THE HINGES AND DOORS 1. Unscrew the bottom hinge pin and re-locate it to the opposite hole on the top of the hinge. (Fig. 13) 2. Attach the bottom hinge spacer and bottom hinge to the cabinet using the bolts originally provided. Be sure to use the top two mounting holes on the hinge and the bottom hole on the same side that the hinge is being moved to. Fig. 16 Thimble Hole Fig. 13 3. Flip the center hinge according to the diagram below and attach the hinge spacer and hinge to the cabinet. (Fig. 14) Do not install the center hinge pin yet. Fig. 14 Do Not Over-Tighten 5. Remove the top thimble plug on the hinge side of the freezer door and relocate it to the opposite thimble hole. Place the door onto the center hinge pin, being sure that the pin goes fully into the bottom thimble hole. Tape may be used as it was during the removal steps to hold the door in place during the next step. 6. Place the top hinge pin into the thimble hole on the same side as the lower hinges. PAGE 11 • SET UP & USE