Hayward TriStar XL HCP3000 Series Variable Speed Pump - Owners Manual - Page 12

This pump can communicate with and be controlled by Hayward pool controls such as OmniLogic™, ProLogic®, ECommand® 4, OnCommand®, OmniHub, S3 Omni, and OmniPL. Minimum software revision requirements: OmniLogic R1.0.0, ProLogic 3.00, OnCommand 1.00, E-Command 2.65, E-Command 4 2.80, AquaLogic 2.65, and AquaPlus 2.65. To determine Hayward control software revision, consult the pool control installation manual or visit our website at: www. haywardpool.com. Connection wire must be rated for a minimum of 300V, and may be up to 500 feet in length. Use removable 4-position terminal block connector for wiring connection to motor drive PCB, taking care to note the wire colors and corresponding numbers next to the connectors. Terminal block must be installed with screws facing up to ensure proper connection. ATTENTION - THIS PUMP CAN ALSO BE SET SO THAT IT WILL CONTINUE RUNNING IN THE EVENT OF COMMUNICATION LOSS. When inputs are activated via wire jumpers, the pump will respond to a communication loss (after a 4 minute delay) as follows: 1. No inputs connected: pump remains stopped 2. INP1 connected: pump runs 3450 rpm for 8 minutes, then 1725 rpm 3. INP2 connected: pump runs 3450 rpm for 8 minutes, then 2600 rpm 4. INP3 connected: pump runs 3450 rpm See page 13 for details regarding input connections (relays would not be used when connecting inputs to set comm loss behavior; use short jumpers in this case). Note: Prior to drive comm revision 10.10, pump response was as follows: no inputs connected - pump runs 3450 rpm for 8 minutes then 1725 rpm; INP1 connected - pump runs 3450 rpm for 8 minutes then 2600 rpm; INP2 connected - pump runs 3450; INP3 connected - pump remains stopped. Jumpers, if used to set desired behavior in the event of communication loss, need to be installed at initial pump installation. When communicating with the Omni family of controls, the HUA (Hayward Unique Address) is used for communication. For all other Hayward controls, the pump address must be set using the DIP switches on the drive PCB. To determine which address should be used, consult the appropriate Hayward pool control installation manual, or visit our website at www.haywardpool.com. Pump addresses are set according to the table below. DIS SWITCH STATUS PUMP ADDRESS #1 #2 #3 #4 #5 Pool Filter OFF OFF OFF OFF OFF AUX 1 / Spa Filter OFF ON OFF OFF OFF AUX 2 OFF OFF ON OFF OFF AUX 3 OFF ON ON OFF OFF AUX 4 OFF OFF OFF ON OFF AUX 5 OFF ON OFF ON OFF AUX 6 OFF OFF ON ON OFF AUX 7 OFF ON ON ON OFF AUX 8 OFF OFF OFF OFF ON AUX 9 OFF ON OFF OFF ON AUX 10 OFF OFF ON OFF ON AUX 11 OFF ON ON OFF ON AUX 12 OFF OFF OFF ON ON AUX 13 OFF ON OFF ON ON AUX 14 OFF OFF ON ON ON Lights Button OFF ON ON ON ON 11 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS