HealthRider E730 Elliptical Canadian English Manual - Page 16

MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the elliptical crosstrainer regularly. Replace any worn parts immediately. For smooth operation of the elliptical crosstrainer, the incline frame should Incline Frame be kept clean. Using a soft cloth and mild detergent, clean dust and other residue from the incline frame where the wheels make contact with it. Other parts of the elliptical crosstrainer can also be cleaned in this man- ner. Never use abrasives or solvents. HOW TO LEVEL THE ELLIPTICAL CROSSTRAINER If the elliptical crosstrainer does not sit flat on the floor, one or both of the leveling pads Jam Pad Nut should be adjusted. First, loosen the jam nut on each leveling pad. Next, turn the leveling pads as needed until the elliptical crosstrainer is level. When the leveling pads are properly adjusted, firmly retighten the jam nuts. CALIBRATING THE RESISTANCE AND INCLINE SYSTEMS If the elliptical crosstrainerʼs resistance or incline system is not working properly, you may need to activate the calibration process. To activate the resistance calibration process, press the RESISTANCE t button. Wait for the resistance motor to stop. Next, press the RESISTANCE s button. While the resistance motor is running, unplug the power cord from the wall. Wait for a few seconds and then plug the power cord back in. The resistance system will now calibrate itself. It will not need to be calibrated again. To activate the incline calibration process, press the INCLINE t button. Wait for the incline motor to stop. Next, press the INCLINE s button. While the incline motor is running, unplug the power cord. Wait for a few seconds and then plug the power cord back in. The incline system will now calibrate itself. It will not need to be calibrated again. PULSE SENSOR TROUBLESHOOTING • Avoid moving your hands while using the pulse sensor. Excessive movement may interfere with heart rate readings. • Do not hold the metal contacts too tightly; doing so may interfere with heart rate readings. • For the most accurate heart rate reading, hold the metal contacts for about 15 seconds. • For optimal performance of the pulse sensor, keep the metal contacts clean. The contacts can be cleaned with a soft cloth-never use alcohol, abrasives, or chemicals. MOVING THE ELLIPTICAL CROSSTRAINER Before moving the elliptical crosstrainer, adjust the incline to Handlebar the highest setting by pressing the INCLINE s button. Wait until the incline frame has stopped moving and then unplug the power cord. Incline Stand in front of the Frame elliptical crosstrainer, hold the handlebar firmly, and tip the Rollers elliptical crosstrainer forward until it can be moved on the two front rollers. Carefully move the elliptical crosstrainer to the desired location. 16